CAN cables with connectors complying with CiA Draft Physical Layer (DS 102-1) serve to connect CAN nodes and include each a male and a female connector of type D-Sub 9. We only use high quality connectors with gold plated contacts and a minimum mating durability of 200 cycles. CAN cables are available in different length from 20cm to 10m.
CAN T–Connectors serve to connect CAN nodes to the CAN bus complying with CiA Draft Physical Layer (DS 102-1). They include each a male and a female connector of type D-Sub 9 for bus line connection and female connectors of type D-Sub 9 for each CAN node.
With the CAN terminating plugs bus termination can be realized with D-Sub 9 connectors according to CiA (DS 102-1).
The following table shows the assignment of the CAN connectors:
| Pin | Bezeichnung | Funktion |
|---|---|---|
| 2 | CAN_L | CAN_L bus line (dominant low) |
| 3 | GND | Ground |
| 6 | GND | Ground |
| 7 | CAN_H | CAN-H bus line (dominant high) |
| 8 | ERROR | Error Signal (optional) |
| 9 | V+CAN | Power supply |
| Parameter | Wert | Einheit |
|---|---|---|
| Core diameter pin 2, pin 6, pin 7, pin 8 | 0,2 | mm² |
| Core diameter pin 3, pin 9 | 0,4 | mm² |
| Current rating pin 2, pin 6, pin 7, pin 8 | max. 2 | A |
| Current rating pin 3, pin 9 | max. 4 | A |
| Operating voltage | max. 300 | V |
| All values, unless otherwise specified, refer to an environmental temperature of maximal 30°C. | ||
All pins of the CAN T-Connector are wired one to one.
| Parameter | Wert | Einheit |
|---|---|---|
| Current rating pin 3 | 4 | A |
| Current rating pin 1, pin 2, pin 4, pin 5, pin 6, pin 7, pin 8, pin 9 | 2 | A |
| Parameter | Wert | Einheit |
|---|---|---|
| Resistor (tolerance 1%) | 124 | Ω |
| Power rating (at 70°C) | 0,6 | W |